High switching frequency and a current mode architecture enable a very fast transient response to line and load changes without sacrificing stability.
1.2 volts power supply
This switch mode power supply circuit require an input voltage range , between 4.5V to 16V,and will provide a very stable output voltage of 1.2 volt . The LTM4627 supports an output voltage range of 0.6V to 5V, set by a single external resistor , so you can modify the output voltage .
High switching frequency and a current mode architecture enable a very fast transient response to line and load changes without sacrificing stability.
1.2 volts power supply
High switching frequency and a current mode architecture enable a very fast transient response to line and load changes without sacrificing stability.
Subscribe to:
Post Comments (Atom)
Popular Posts
-
Circuit diagram 500mW FM PLL transmitter 88-108MHz using LMX3206 – PIC16F870 Circuit diagram 500mW FM PLL transmitter 88-108MHz 500mW P... -
STK4132II - Schematic audio amplifier - power amplifier 2x20w STK4132II - Schematic audio amplifier.STK4132II power audio amplifier schematic -
0 - 300V Adjustable Power Supply Introduction To prevent my high voltage experiments to go up in smoke completely, I designed a simp... -
In the circuit diagram shown, BA5406 is configures to deliver 5×2 watts into 4 ohm loudspeakers at a supply offer voltage of 9 volts. C... -
device is the amplifier (MRF 455 ‡ 60 watts max rf power or MRF 454 ‡80 watts rf power ) The purpose of this amplifier is to lower output e... -
ON - OFF VIA MOMENTARY PUSH-BUTTONS This circuit will supply current to the load RL. The maximum current will depend on the second transi... -
Broadband Colpitts VCO for TV Tuner The high performance of modern set-top DBS TV tuners require broadband voltage control oscillator (VCO... -
An oscillator is a system or device that oscillates, or moves back and forth, between two states or conditions. Oscillators can be found in...
0 comments:
Post a Comment